Strautmann PP 1207 - 2.3 Intended use; 2.4 Residual risk; 1.4 Instruction and training aids; 1.5 Examples of training topics

Contents
V 152 10 11 Rev.: END
3.4 Hydraulic system ........................................................................................ 3-3
3.5 Technical data ............................................................................................. 3-4
4 Transportation and installation ......................................... 4-1
4.1 General information .................................................................................... 4-1
4.2 Transportation by crane ............................................................................. 4-1
4.3 Transportation with floor conveyor ........................................................... 4-3
4.4 Assembly ..................................................................................................... 4-3
4.4.1 Installation .............................................................................................................................. 4-3
4.4.2 Electrical connection ............................................................................................................. 4-4
4.4.3 Hydraulic system ................................................................................................................... 4-5
4.5 Checklist ...................................................................................................... 4-5
5 Operation and control ........................................................ 5-1
5.1 General information .................................................................................... 5-1
5.2 Controls and displays ................................................................................. 5-2
5.2.1 Controls for two-handed control (only for hydraulic door lock)....................................... 5-3
5.3 Switching on the gantry press ................................................................... 5-4
5.3.1 Starting the gantry press in automatic mode: .................................................................... 5-4
5.3.2 Starting the gantry press in manual mode: ........................................................................ 5-4
5.4 Gantry press operation ............................................................................... 5-4
5.4.1 Preparing the press chamber ............................................................................................... 5-4
5.4.2 Loading and compressing .................................................................................................. 5-10
5.4.3 Finishing and tying up bales .............................................................................................. 5-11
5.4.4 Removing bale, finishing work ........................................................................................... 5-12
5.5 Faults in operational sequence ............................................................... 5-13
6 Servicing ............................................................................. 6-1
6.1 Care .............................................................................................................. 6-2
6.2 Cleaning schedule ...................................................................................... 6-3
6.3 Maintenance ................................................................................................ 6-6
6.3.1 General maintenance instructions ....................................................................................... 6-6
6.3.2 Safe maintenance of electrical equipment .......................................................................... 6-7
6.3.3 Safe maintenance of hydraulic equipment ......................................................................... 6-7