47
Issued: 24.02.2005
STRIDER MX
It is imperative that you observe the
sequence for connecting and
disconnecting the battery charger.
(2.) Connect the battery charger
mains plug (5) to a mains socket
and switch on.
➨
The jack socket (3) for connecting the
battery charger is located on the left
of the tiller.
(1.) Connect the battery charger plug (4)
to the Strider charging socket.
➨
Connecting the battery
charger
Charging the batteries
Switch the Strider off.➨
Switching off
Engaging
Engage the engaging lever for push
mode into the “drive“ position.
➨
12.2 Charging the batteries
NOTE
The battery charger switches
on automatically when
connected to the mains.
To Next Page
Loading...
