Strider MX 4 - Reinserting the batteries

62
Issued: 24.02.2005
STRIDER MX
Place the batteries in the frame so that
the battery terminal is facing inwards.
➨
Reinserting the batteries
14.4.4 Reinserting the batteries
Transporting the Strider
Screw the brake cable wing nut (13)
on and adjust the handbrake.
➨
Caution: accident hazard
After a new brake cable has been
inserted, the handbrake must be
adjusted.
• Please see Chapter 18.3.5 for
information about adjusting the
handbrake.
Screwing down the
brake cable
Route the safety straps (9 + 10) around
the front of the batteries as illustrated in
the photograph and tighten.
➨
NOTE
Please note that the strap (11)
should be routed above the
clamping lever.
Route the safety straps (11 ) around the
front of the batteries as illustrated in the
photograph and tighten.
➨