Strider MX 4 - Wheels - removal and replacement - 3-wheel version

77
Issued: 24.02.2005
STRIDER MX
18.3.2 Wheels - removal and replacement - 3-wheel version
Secure the Strider against rolling away.
Lift the front end of the Strider and
support it (see chapter 19.0).
Remove the wheel fixing protective cap
(1) with a screwdriver.
Hold the axle (2) with a ring spanner
(size 14 mm) and remove the self-
locking nut (3; size 17 mm).
Pull the axle out of the steering fork and
the wheel.
Remove the wheel and spacer bushes
from the steering fork.
➨
➨
➨
➨
➨
➨
Tools required:
1 x ring spanner, size 14 mm
1 x ring spanner, size 17 mm
Removing the front wheel:
Front wheel
Removal and replacing the rear wheel:
Removing and replacing the rear wheel
must be carried out as described in the
chapter “Removing and replacing wheels -
4-wheel version“.
Replacing the front wheel:
Repairs - mechanics
Fitting the front wheel
Place the wheel and spacer bushes
(4+5) in the steering fork.
Push the axle (2) into the steering fork
and the wheel.
Screw the axle self-locking nut (3) and
tighten it (size 17 mm). While doing this,
prevent the axle from turning using a
second ring spanner (size 14 mm).
Lower the Strider.
➨
➨
➨
➨
Press the protective cap onto the
wheel fixing nut.
➨