Safety Regulations
2 — 12
03_0082_0606GB
The control cabinet, electrical wiring and drive motor pose a risk of
f
atal injury from electrical contact during the following:
-- Starting up
-- Operation
-- Cleaning, Troubleshooting, Maintenance
-- Decommissioning.
All electrical assemblies are protected as standard, as per IEC
60204 Part 1 or DIN 40050 IEC 144 in accordance with protection
category IP 44.
Use only original fuses with the specified amperage! The electrical
system can be destroyed by over-rated fuses or bridging.
High voltage
Work on the electrical system and equipment of the machine must
be carried out by a qualified electrician or by instructed persons
under the supervision and guidance of a qualified electrician and in
accordance with the electrical engineering rules and regulations.
2.10 Electrical contact
To Next Page
Loading...