Strobl Strocomp 433 - Setting the Working Pressure

Operation
6 — 3
05_0184_0802GB
You must set the working pressure before operating the machine.
R
efer to the chapter: ”General Technical Description” -- section:
”Technical data” for information on the maximum delivery pressure
of the machine.
" Attach the other end of the air hose to a suitable pneumatic
tool.
Caution
Read the information provided by the manufacturer before
connecting ”pneumatic tool” accessories.
The maximum values must not be exceeded.
1
2
3
Different models available
Item Designation
1 ”Working pressure” gauge
2 ”Working pressure” handwheel
3 ”Tank pressure” gauge
Adjust the working pressure at the pressure-reducing valve as
follows:
" Switch the machine on. Refer also to chapter:
”Starting up” -- section: ”Switching on the machine”.
Continued next page
6.3 Setting the working
pr
essure