Operation
6 — 5
05_0185_0802GB
You may begin using the machine once the start-up phase is
c
omplete.
Danger
The machine may be operated only with a pneumatic tool con-
nected!
Proceed as follows:
" Switch the machine on. Refer also to chapter:
”Starting up” -- section: ”Switching on the machine”.
" Set the working pressure. Refer also to section:
”Setting the working pressure”.
" Open the air supply on the pneumatic tool.
⇒ The pneumatic tool is now ready for use.
Caution
Never disconnect the machine during operation.
Otherwise the machine may be damaged.
Interrupt operation as follows:
" Close the air supply to the pneumatic tool.
⇒ The compressor switches off automatically.
Resume operation as follows:
" Open the air supply to the pneumatic tool again.
⇒ The compressor switches on again automatically.
6.4 Operating the
m
achine
Interrupting operation
Resuming operation
To Next Page
Loading...