14
4.3 Channel search
In order to view video programmes, you must do a channel search with or without smartcard in order to
install the channel list of your choice.
For HD+ channels, rst insert HD+ smartcard at the right-hand side of the receiver before you start the
channel search. Then the receiver will install the associated channel list of the HD+ bouquet (FTA and
encrypted).
For FTA only channels or for channels from other satellites you do not need to insert a HD+ smartcard.
Select the search scheme you wish the wizard to follow:
1. Select HD+ channel scan to search for channels of the HD+ bouquet (channels 100 and above).
2. Select Preinstalled channels to restore a predened German channel list from the receiver’s memory
(channels 1~99).
3. Select Satellite edit to search for channels on all transponders for the selected satellite (channels above the
HD+ bouquet).
NOTE: After selection 1 to load HD+ bouquet with inserted HD+ smartcard. Select after this
installation in menu to install selection 2. Then this Preinstalled channel list will contain aswell
HD+ channels.
Finding and storing the channels
Select preferred option or press the OK button on the remote control to start the channel search. Once a
channel search has started, a progress bar and list of channels will be displayed. At any time, you may stop
the search by pressing
on the remote control. After the channel search is completed, the receiver will save
all found channels into the channel list and exit to the preview mode.
NOTE: If you see the messages No list found or No channels found, please check the antenna
connections and signal levels of the satellite dish.
5. QUICK GUIDE FOR USING YOUR RECEIVER
We at STRONG understand that you can’t wait to enjoy your new HD+ receiver.
However, we advise you to read this manual to get the best performance from your STRONG HD+ receiver.
To turn your receiver On or to go to Standby mode, press q on the remote control. Choose channels with
CH+/ or p q. Alternatively, you can also enter the channel number with the 0~9 buttons on the remote
control or press OK in viewing mode to display the channel list. The volume can be adjusted with VOL+/ or
with t u.
6. OPERATION
In viewing mode, several features are available to make watching TV a true pleasure. This paragraph
describes these features. Please also read chapter 7 to get familiar with the menu of your new HD+ receiver.
6.1 Selecting channels
There are dierent ways to change channels with your receiver.
Via direct access
Via the channel list
Via the CH+/ or p q buttons
Via the
button
To Next Page
Loading...
