14
Use this menu to delete all stored channels. Select Delete All with p q and press . The receiver
asks you to enter the pin code. . In the confirmation window select Yes with t
u and press to delete or select No to cancel.
The Delete all function will permanently delete all current channels and all
favourite lists from your receiver, and you are not able to leave the menu until
you search for channels again.
Use p q to select Installation, press or u to advance.
Use p q to select Channel Scan and press to enter.
Use t u to toggle between available scan modes: By Channel and By Frequency.
If By Channel is selected, use the cursor buttons to select Scan Band and Channel No. If By Frequency is
selected, use the cursor buttons to select Frequency and Bandwidth. Highlight Search and press to
start scanning. Newly found channels will be stored in the channel list.
Use p q to select Installation and press or u to advance.
Select Auto Scan with p q and press to enter.
Use t u to toggle between FTA Only Yes or No. When FTA Only is set to Yes, scrambled channels won’t
be stored in the channel list. Use p q to highlight Search. Now press to start auto scan.
The receiver will store all newly found channels in the channel list.
If LCN (Logical Channel Numbering) is activated and an LCN signal is provided by the operator,
channels will be stored in an operator defined order. Set LCN to On to activate operator defined
channel numbering or Off to store channels in found order.
Use this menu to setup Antenna Power, Power saving mode and usage of signal to Antenna loop out.
Set to On if you use an active antenna. When set to On, 5 Volt with a maximum current of 50 mA will
be present on the ANT IN connector of the receiver. Select Off for passive antennas. The included
antenna is an active type. If you use this antenna, keep the selection to On.
Auto Standby is a new feature that helps you reducing power consumption. When set to On, the
receiver will turn to standby if it doesn’t receive any commands for three hours. Set Auto Standby to
Off to avoid the automatic switch down.
To Next Page
Loading...
