After moving the
receiver to another
room/area you
are no longer able
to receive digital
reception
Antenna signals are too weak Press the button on remote 2x to
call up signal bars and adjust antenna for
(maximum) reception
or rescan channels
The receiver
switches off
automatically.
Auto Standby function
enabled.
Disable auto standby. See section
for details.
Demodulator: COFDM; 16 QAM/64 QAM, QPSK
Transmission mode: 2 K - 8 K
Profile level: MPEG-2 MP@ML, AVC/H264HP@L4.1, MPEG-4 ASP
supported
Video resolutions: 480i/576i/576p/720p/1080i/1080p
Decoding & Video out: PAL
Aspect ratio: 4:3 Letterbox, 4:3 Pan & Scan, 16:9, Auto
Audio support: AAC/Dolby® Digital Plus*/AC3/PCM
MPEG MusiCam Layer II
Sampling rate: 32, 44.1, 48 kHz
Audio mode: Stereo, Joint Stereo, Dual Mono, Mono
*Dolby and the double-D symbol are registered trademarks of Dolby Laboratories
Front End: DVB-T, UHF & VHF Tuner
Input frequency range: 174 ~ 230 MHz (VHF) and 470 ~ 862 MHz (UHF)
Loop through frequency range: 47 ~ 862 MHz
Input signal level: -82 ~ -20 dBm
UHF RF modulator, channels 21 – 69, default channel 38
Flash memory: 4 Mbytes
SDRAM: 128 Mbytes
To Next Page
Loading...
