After performing this function, the USB device is no longer accessible from
your receiver. To gain access to your storage device again, re insert it or
switch the receiver to standby and on again.
8.0
There may be various reasons for abnormal operation of the receiver. Check the receiver according to
the procedures shown below. If the receiver does not work properly after checking it, please contact
your dealer or the local Service Hotline. Do NOT try to open or disassemble the receiver. It may cause
a dangerous situation and warranty
LED indicator not lit Mains lead unplugged Check mains plug
No signal found Aerial is disconnected
Aerial is damaged/
misaligned
Out of digital signal area
Active antenna requires to
switch ON antenna power/
external power
Check aerial lead
Check aerial
Check with dealer
Switch receiver’s antenna power ON/
connect external power
No picture or sound
on TV
HDMI is not selected on
your TV or Amplifier or is set
to higher resolution as TV
supports
TV is not switched on
Switch to correct TV input
Select lower resolution by pressing the
button on the remote control.
Switch on the TV.
Picture is only in
black and white
The video resolution is
selected on 50 or 60 Hz
Press the button and select
another frequency resolution
No picture or
interference when
using the RF
modulator.
Modulator on wrong channel
or wrong TV system.
Interference on TV when
using modulator.
Select other channel, or let TV scan for
signal. Use correct TV system for your
region.
Select other channel.
Scrambled channel
Message
Channel is scrambled Select alternative channel
No response to
remote
control
Receiver off
Remote not aimed correctly
Front panel obstructed
Remote batteries exhausted
Plug in and turn on plug
Aim remote at front panel
Check for obstructions
Replace remote batteries
Forgotten PIN code
Contact local Service Hotline or send email
to our Support via www.strong.tv
To Next Page
Loading...
