Strong SRT 8205 - 2.3 Rear Panel; 2.4 Remote Control Unit (RCU)

2. IR sensor: Point your RCU towards this sensor.
3. Mode indicator: RED indicates that the receiver is in STANDBY mode.
GREEN indicates that the receiver is in OPERATING mode
2.3 Rear Panel
Fig. 2
1. RF IN To connect to your antenna for reception of broadcasted signals.
2. RF OUT To connect your extra receiver
3. CVBS connector (output, yellow)
To connect your receiver to your TV set using corresponding
video input in your TV.
4. AUDO L/R connector (output, white/red)
To connect your receiver to your TV set using corresponding right
and left channels of audio inputs in your TV or stereo system.
5. HDMI To connect your receiver with your TV set using an HDMI cable
6. Power adapter connector (at side)
To connect power adaptor supplied with the receiver. Please, use
only original adapter.
2.4 Remote Control Unit (RCU)
Fig. 3
1. q Switches the receiver On/Standby
2. ! Mutes all audio outputs of the receiver
3. 0 ~ 9 Enters a channel number in viewing mode or a value inside the
respective menu
4. EPG Opens the EPG (Electronic Programme Guide) in TV mode
5. AUDIO Opens the audio language selection
6. SUBTITLE Shows a list of subtitle languages
7. INFO Opens the current channel information; 2x opens the current
event information and 3x the signal information
8. RECALL Back to previously watched channel
9. TV/RADIO Toggles between TV or RADIO mode
10. MENU Opens the main menu, in a menu you will get one step back
11. EXIT Exits from the menu or sub-menu
12.  Menu O : Change channel to next/previous.
Menu On: Moves the cursor up/down
13.  Menu O : Decreases/increases the volume level
Menu On: Change settings for speci c menus
14. OK Menu O : Displays the current channel list
Menu On: Activates the highlighted menu item
15. RECORD Records the TV programme to the connected USB storage device
16. 3 Stops recording or Timeshift
17. VOL+/VOL Increases/decreases the volume level
18. TTX Displays Teletext on the OSD (On Screen Display)
19. CH+/CH Page up/down in channel list mode. Change channel to next/
previous in no menu state
6