Strong SRT 8205 - 7.1.4 Rename Favourite list; 7.2 Installation; 7.2.1 Auto Scan; 7.2.2 Channel Scan

WARNING: The Delete All function will permanently delete all current channels and
all favourite lists from your receiver and you will not be able to leave the
menu until you search for channels again.
7.1.4 Rename Favourite list
This menu allows you to personalize the names of the 8 available favourite lists.
Use  to select Rename Favourite List.
The names of all groups are now displayed.
Select a favourite group with  and press OK to edit its name.
A text  eld will now pop up at the right of the screen. Use   to select characters and enter
them with OK.
When you have  nished editing, press BLUE to save the changes.
When all changes have been made, press EXIT twice to leave this menu.
7.2 Installation
Use  to select Installation and press OK or  to enter.
It consists of following sub menus: Auto Scan, Channel Scan, Antenna Power and LCN
7.2.1 Auto Scan
Select Auto Scan with  and press OK to enter.
Use  to toggle between Yes or No.
When FTA Only is set to Yes, scrambled channels won't be stored in the channel list.
When T2 Signal Only is set to Yes, DVB-T channels won't be stored in the channel list.
When T2-Lite Support is set to No, DVB-T2-Lite channels won't be stored in the channel list.
Use  to highlight Search. Now press OK to start auto scan.
The receiver will store all found channels in the channel list.
7.2.2 Channel Scan
Use  to select Channel Scan and press OK to enter.
Use  to toggle between available scan modes: By Channel and By Frequency.
If By Channel is selected, use the cursor buttons to select Scan Band and Channel No.
If By Frequency is selected, use the cursor buttons to select Frequency and Bandwidth.
Option Network Search select Yes or No. If set to Yes the receiver will use additional information
provided by the operator to optimize the searching process.
Highlight Search and press OK to start scanning.
Newly found channels will be added to the channel list.
7.2.3 Antenna Power
Use  to select Antenna Power and press OK to enter.
Set to On if you use an active antenna.
Select O  for passive antennas.
When set to On, 5 V will be present on the RF IN connector of the receiver.
15