Strong SRT 8205 - 9.0 Technical Specifications

The receiver switches
o automatically.
Auto Standby function enabled. Disable auto standby. See section
7.3.7 for details.
Playback of video (or
Timeshift) is causing
picture freeze/macro
blocks or similar
distortion, especially on
HD content.
Read/write speed of your USB
device could be too low.
Make sure to use a USB storage
device with su cient speed and
space. Pen drives (‘USB sticks') may
not support su cient speed.
9.0 TECHNICAL SPECIFICATIONS
Demodulator
Demodulator: QSPK, 16/64/256 QAM
DVB-T2 (EN 302 755)
Transmission mode: 1K, 2K, 4K; 8K, 16К, 32К normal and extended
Guard intervals: DVB-T2 = 1/128, 1/32, 1/16, 19/256, 1/8, 19/128, 1/4
Video Decoder
Pro le level: MP@HL, MPEG-4 H.264/AVC
Video resolutions: 480i, 480p, 576i, 576p, 720p, 1080i, 1080p
Decoding & Video out: PAL
Aspect ratio: 4:3 Letterbox, 4:3 Pan & Scan, 16:9, Auto
Audio Decoder
Audio support: MPEGI Layer I/II
Sampling rate: 32, 44.1, 48 KHz
Audio mode: Stereo, Mono
Tuner
Front End: DVB-T2, UHF & VHF Tuner
Antenna power: DC 5 V, 50 mA, shortcut protected
Input frequency range: 174 – 230 MHz (VHF) and 470 - 862 MHz (UHF)
Input signal level: -20 ~ -82 dBm
Memory and System
Flash memory: 4 MB
SDRAM: 64 MB
Multimedia
Video playback: AVI, MKV, TS, M2T, M2TS, MPEG-4 and MOV*
Audio playback: MP3 and OGG
Picture view: BMP and JPEG
*STRONG cannot guarantee the playback of video  les although extensions are listed, as it depends on codec used, data bit rate and resolution (all
MPEG codec formats are supported).
Connectors
RF IN - IEC Female
23