Strong SRT 8205 - 7.3.3 Local Time Setting; 7.3.4 Timer Setting

ratio, 4:3 PS - Displays 16:9 widescreen broadcasts full screen on your 4:3 TV,
4:3 LB - black bars on top and under the picture on a 4:3 TV and 16:9 - use this
setting for 16:9 TV sets.
Digital Audio Output: Toggles between PCM and BIT Stream output. When PCM is selected, all
digital audio will be converted to (analogue) stereo audio. BIT Stream enables
you to listen or transfer Dolby® Digital/ Dolby® Digital Plus* audio to the TV
via HDMI or to a Home entertainment system (for example) through coaxial
S/PDIF.
*Dolby and the double-D symbol are registered trademarks of Dolby Laboratories
7.3.3 Local Time Setting
Here you can set up your region and time zone.
Region: Use  to select the region you live in.
GMT Usage: Set to By Region for broadcaster de ned time, User De ne to select manual a
GMT zone or to O  to input time and date manually.
GMT O set: Allows you to adjust your time zone. This option is only available when
GMT Usage is set to User De ne.The GMT O set range is “-11:30 ~ +12:00”,
increasing by half hours progressively. The cities matching the set GMT O set
are displayed at the bottom of the screen.
Daylight Saving: Select O  or On to add one hour for summer time.
Date: Date and Time settings are available only when GMT Usage is set to O  . Use
the 0~9 buttons to enter the date. Press EXIT to proceed.
Time: Date and Time settings are available only when GMT Usage is set to O  . Use
the 0~9 buttons to enter the time. Press EXIT to proceed.
Time Display Select On to display time on screen, O  to remove.
7.3.4 Timer Setting
This menu allows you to set up to 8 timed events for recording or waking up the receiver.
Select the timer you wish to set or change with  and press OK to proceed.
The timer setup menu will now be displayed.
The following settings are available:
Timer Mode: Choose between O  the timer is inactive, Once, Daily (the timer will be
executed every day, same time) or Weekly (the timer will be executed every
week, same day, same time) and Monthly (the timer will be executed every
month, same day, same time).
Timer Service: Choose between Channel (the timer will wake up the receiver) or Records
(Timer will start recording the scheduled event).
Wakeup Channel: Use  to select the channel the timer will wake up with.
Wakeup Date: Use the 0~9 buttons to enter the date for the timed event.
Wakeup Time: Use the 0~9 buttons to enter the starting time.
Duration: Use the 0~9 buttons to enter the duration of the timer.
When all settings have been made, use  to move the highlight to Save and press OK to con rm.
To quit the timer without saving your settings, move the highlight to Cancel.
17