Setup Press INFO to access slideshow settings. You can change the slide time and
slideshow repetition.
MultiView Press 3 to show the les in a preview of 3x3 pictures.
EXIT Press EXIT to go one step back or leave the folder and quit the function.
7.5.5 HDD Information
This option shows relevant information about the connected USB device.
In this menu you can also format your USB storage device and setup the recording type.
Select HDD Information and press OK to enter.
Now you will see all details as Free and the used Recording Sizes and the used le system.
Press the YELLOW button Format to format the connected USB device.
Please, enter your PIN code to access this menu and press OK to start formatting.
WARNING: Formatting will permanently delete ALL data stored on the connected
device. Please make a backup copy of all data you wish to keep before
entering the HDD Format menu. STRONG cannot be held responsible for
loss of data from USB devices used with this receiver.
Select FAT and OK to proceed.
Select Cancel or press EXIT to leave without formatting.
NOTE: It is possible to use USB storage devices already formatted in NTFS.
Press EXIT to leave this menu.
7.5.6 DVR Setting
This menu allows you to con gure settings for Timeshift, recording and playback.
Select DVR Setting and press OK to enter.
Timeshift: Select between Auto, Pause or O . When Timeshift is set to Auto it will
automatically start every time after zapping to a channel. When Timeshift
is set to Pause it will start only after pressing the 2 button. Select O to
deactivate Timeshift.
Step to: 30 sec to 30 min. Set the time step you like to jump during playback.
After Recording: Go to Standby-mode or Watch TV. If set to Go to Standby-mode then receiver
will be switched to Stand-by after record by Timer is completed. If set to
Watch TV then receiver would not be switched to stand-by after record by
timer. In this case switching to Stand-by will be done according to “Auto
Standby” settings. Refer to chapter 7.3.7.
Press EXIT to leave this menu.
7.5.7 Remove USB device safely
Select Remove USB device safely from the tools menu and press OK. The receiver will display a
message indicating that you can safely remove your storage device from the receiver.
21
To Next Page
Loading...
