Struers LectroPol-5 - Location Requirements

Pcs. Description
1 Water hose
1 Set of masks:
• ½ cm
2
• 1 cm
2
• 2 cm
2
• 5 cm
2
• one mask without a hole
1 Calibration tube. Packed in a cardboard tube
2 Electrolyte container
1 Pressure hose
1 Protective cover
1 Instruction Manual set
Control unit
See the Instruction Manual for this unit.
5.3 Location
CRUSHING HAZARD
Take care of your fingers when handling the machine.
Wear safety shoes when handling heavy machinery.
WARNING
Place the unit in a fume cabinet.
Do not touch, move or tamper with the unit during use.
• Place the unit in a fume cabinet.
• Place the unit on a rigid, stable workbench with a horizontal surface and an adequate height.
The workbench must be resistant to chemicals.
• Place the unit close to the water supply or to a separate cooling unit.
• The length of the supply and communications cable connecting the two units is 2m (6.5ft), so
that the units can be placed in separate locations.
Control unit
See the Instruction Manual for this unit.
20 LectroPol-5
5 Installation