6.1 Starting the machine the first time
See the LectroPol-5 Control unit instruction manual.
7 Maintenance and service
Proper maintenance is required to achieve the maximum up-time and operating lifetime of the
machine. Maintenance is important in ensuring continued safe operation of your machine.
The maintenance procedures described in this section must be carried out by skilled or trained
personnel.
Safety Related Parts of the Control System (SRP/CS)
For specific safety related parts, see the section "Safety Related Parts of the Control System
(SRP/CS)" in the section "Technical data" in this manual.
See Safety Related Parts of the Control System (SRP/CS) ►31
Technical questions and spare parts
If you have technical questions or when you order spare parts, state serial number and
voltage/frequency. The serial number and the voltage are stated on the type plate of the machine.
7.1 General cleaning
To ensure a longer lifetime for your unit, Struers strongly recommends regular cleaning.
Hint
Do not use a dry cloth as the surfaces are not scratch resistant.
Hint
If needed, use ethanol or isopropanol to remove grease and oil.
Note
Do not use acetone, benzol or similar solvents.
Note
Always remove the electrolyte when the machine is not in use.
If the unit is not to be used for a longer period of time
• Clean the unit thoroughly. See Daily ►24.
7 Maintenance and service
LectroPol-5 23
To Next Page
Loading...
