Black plate (181,1)
北米Model "A1100BE-A" EDITED: 2010/ 3/ 23
WARNING
Continued operation with the air
inletselectionbuttonintheON
position may fog up the windows.
Switch to the OFF position as soon
as the outside dusty condition
clears.
& Heater operation
NOTE
. When the “ ” or “ ” position is
selected, the air conditioner compres-
sor automatically operates regardless
of the position of the air conditioner
button to defog the windshield quickly.
At the same time, the air inlet selection
is automatically switched to the OFF
position (outside air). However, the air
conditioner indicator light does not
illuminate at this time.
. When defrosting, defogging or heat-
ing, warm air also flows out the right
andleftairoutlets.Tostopwarm
airflow from these outlets, turn the
corresponding thumb wheel down.
! Defrosting or defogging the wind-
shield
To direct warm air to the windshield and
front door windows:
1. Set the airflow control dial to the “
”
position.
2. Turn the temperature control dial all
the way to the right.
3. Set the fan speed control dial to the
highest speed.
! Heating and defrosting
To direct warm air toward the floor and the
windshield:
1. Set the airflow control dial to the “
”
position.
2. Set the temperature control dial to the
most comfortable level.
3. Set the fan speed control dial to the
desired speed.
Climate control 4-5
– CONTINUED –
4
To Next Page
Loading...
