Subaru 2011 Impreza - MUTE Button; Bluetooth Audio (Type C Audio); Media Format; Setting Bluetooth Audio

Black plate (237,1)
北米Model "A1100BE-A" EDITED: 2010/ 3/ 23
& MUTE button (models with-
out Hands-free system)
Press the “ ” button if you wish to
immediately cut the volume to zero.
The audio display will show “MUTE”.
If you press the button again, the original
sound volume will return and “MUTE”
turns off.
Bluetooth
®
audio (type C
audio)
This function enables you to play back
audio sources recorded in Bluetooth
®
audio devices. You need to register the
Bluetooth
®
audio device in the system
before using it.
& Media format
Bluetooth
®
audio devices cannot be
connected if they are not compatible with
the following Bluetooth
®
profiles.
. A2DP (Advanced Audio Distribution
Profile)
. AVRCP (Audio/Video Remote Control
Profile)
& Setting Bluetooth
®
audio
Perform the following procedure while
“BT-A” is displayed.
NOTE
You cannot set a Bluetooth
®
audio
while driving.
! Registering (pairing) device
1. Select the “PAIR AUDIO” menu by
operating the “TUNE/TRACK/CH” dial. If a
device is already registered, “MEMORY
FULL” is displayed and the mode changes
to the Bluetooth
®
audio setting mode.
2. After the passkey is shown on the
display, input the passkey into the cell
phone. If you input the correct passkey,
“PAIRED” is displayed and the registering
procedure is finished. If you input an
incorrect passkey, “FAILED” is displayed,
the registering procedure was not suc-
cessful and the mode changes to the
Bluetooth
®
audio setting mode.
! Selecting device
1. Select the “SELECT AUDIO” menu by
operating the “TUNE/TRACK/CH” dial. If
no devices are registered, “EMPTY” is
displayed and the mode changes to the
Bluetooth
®
audio setting mode.
2. Select the “CONFIRM” menu by oper-
ating the “TUNE/TRACK/CH ” dial. If the
device is connected, “SELECTED” is
displayed and the selecting procedure is
finished. If the device cannot be con-
nected, “FAILED” is displayed and the
selecting procedure was not successful.
! Setting passkey
1. Select the “SET PASSKEY” menu by
operating the “TUNE/TRACK/CH” dial.
After the currently set passkey is dis-
played, a new passkey can be entered.
2. Input the new passkey by operating
Audio 5-45
– CONTINUED –
5