Black plate (149,1)
北米Model "A1120BE-B" EDITED: 2011/ 10/ 28
! Journey time
The journey time shows the time that has
elapsed since the ignition switch was
turned to the “ON” position.
The journey time indication flashes each
time a complete hour has elapsed. If the
display is giving a reading other than the
journey time, the display switches to the
journey time, flashes for 5 seconds, and
returns to its original reading each time a
complete hour has elapsed.
NOTE
The journey time is reset when the
ignition switch is turned to the “LOCK”
position. It is also reset if the ignition
switch i s turned to the “LOCK” or
“ACC” position prior to restarting of
the engine.
! Average vehicle speed
1) U.S.-spec. models
2) Except U.S.-spec. models
This display shows the average vehicle
speed since the trip meter was last reset.
1) Trip knob
Pressing the trip knob toggles the display
between the average vehicle speed cor-
responding to the A trip meter display and
the average vehicle speed corresponding
to the B trip meter display.
When either of the trip meter displays is
reset, the corresponding average vehicle
speed value is also reset.
NOTE
When either trip meter display is reset,
the average vehicle speed correspond-
ing to that trip meter display is not
shown until the vehi cle has subse-
quently covered a distance of 1 mile
(or 1 km).
Instruments and controls 3-27
– CONTINUED –
3
To Next Page
Loading...
