Subaru 2012 Impreza - Light Control Switch; Headlights

Black plate (186,1)
北米Model "A1120BE-B" EDITED: 2011/ 10/ 28
3-64 Instruments and controls
7. The system will notify you that the
setting is complete for approximately 3
seconds.
Light control switch
CAUTION
. Use of any lights for a long period
of time while the engine is not
running can cause the battery to
discharge.
. Before leaving the vehicle, make
sure that the light control switch
is turned to the “
” (off) position.
If the vehicle is left unattended
for a long time with the light
control switch set to a position
other than “
” (off) position, the
battery may be discharged.
NOTE
. Even if the key is removed from the
ignition switch, the lights can be illu-
minated by operating the light control
switch from the “
” (off) position to the
“
” or “ ” position.
. If the driver’s door is opened while
the lights are illuminated and the key is
removed from the ignition switch, the
chirp sound informs the driver that the
lights are illuminated.
& Headlights
To turn on the headlights, turn the knob on
the end of the turn signal lever.
“
” position
Instrument panel illumination, headlights,
parking lights, front side marker lights, rear
side marker lights, tail lights and license
plate lights are on.
“
” position
Instrument panel il lumination, pa rking
lights, front side marker lights, rear side
marker lights, tail lights and license plate
lights are on.