Black plate (166,1)
北米Model "A1120BE-B" EDITED: 2011/ 10/ 28
3-44 Instruments and controls
4. Select an item by operating the “ ” or
“
” switch, and then pull the “ /SET”
switch toward you.
5. Select “Set” by operating the “ ”
switch, and confirm the setting by pulling
the “
/SET” switch toward you.
6. The system will notify you that the
setting is complete for approximately 3
seconds.
& Screen settings
The items in the screen settings can be
set. To change the items, operate the “
”
or “
” switch, and then pull the “ /SET”
switch toward you.
! Preparation for screen settings
1. Turn the ignition switch to the “ON”
position and pull the “
/SET” sw itch
toward you for more than 2 seconds.
2. After the selection screen is displayed,
operate the “
” or “ ” switch to show the
“Screen Setting” item. Then, pull the “
/
SET” switch toward you.
! Top display setting
1. Perform the preparation steps accord-
ing to “Preparation for screen settings”
F3-44.
To Next Page
