Black plate (176,1)
北米Model "A1120BE-B" EDITED: 2011/ 10/ 28
3-54 Instruments and controls
2. Operate the “ ” or “ ” switch to
select the “On/Off” item, and then pull the
“
/SET” switch toward you.
3. The current setting is displayed. Pull
the “
/SET” switch toward you to enter
the selection mode.
4. Select “On” or “Off” by operating the
“
” or “ ” switch, and then pull the “ /
SET” switch toward you.
5. Select “Set” by operating the “ ”
switch, and confirm the setting by pulling
the “
/SET” switch toward you.
6. The system will notify you that the
setting is complete for approximately 3
seconds.
! Clear setting
1. Perform the preparation steps accord-
ing to “Preparation for maintenance set-
tings” F3-52.
To Next Page
