Instruments and controls/Multi function display
3. Select a contrast level by operating the
“
” or “ ” switch, and confirm the setting
by pulling the “
/SET” switch toward you.
! Screen OFF setting
1. Perform the preparation steps accord-
ing to “Preparation for image quality and
volume settings” F3-57.
2. Operate the “ ” or “ ” switch to
select the “Screen OFF” item. Then pull
the “
/SET” switch toward you.
3. Pull the “ /SET” switch once more
toward you.
4. The screen is turned off.
Restoring the screen
When the “
”, “ ” or “ /SET” switch is
pulled toward you after the ignition switch
is turned to the “ON” position, the screen
will be restored. The screen will be
restored with the basic screen that was
displayed when the screen was turned off.
While the screen is off, a warning mes-
sage will be displayed if necessary, but
other screens will not be displayed.
! Beep volume setting
1. Perform the preparation steps accord-
ing to “Preparation for image quality and
volume settings” F3-57.
3-58
To Next Page
Loading...
