2. Operate the “ ” or “ ” switch to
select the “Beep” item. Then pull the “
/
SET” switch toward you.
3. Pull the “ /SET” switch toward you.
4. Select an item by operating the “ ” or
“
” switch. Then pull the “ /SET” switch
toward you.
5. Select “ Set” by operating the “ ”
switch, and confirm the setting by pulling
the “
/SET” switch toward you.
6. The system will notify you that the
setting is complete.
& Screen settings
The items in screen settings can be set.
To change the items, operate the “
” or
“
” switch, and then pull the “ /SET”
switch toward you.
! Preparation for screen settings
1. Turn the ignition switch to the “ON”
position.
2.Pullandholdthe“
/SET” switch
toward you to show the selection screen.
Instruments and controls/Multi function display
– CONTINUED –
3-59
To Next Page
