5. Select “ Set” by operating the “ ”
switch, and confirm the setting by pulling
the “
/SET” switch toward you.
6. The system will notify you that the
setting is complete.
& Image quality and volume
settings
The image quality and volume settings
can be adjusted. To change the items,
operate the “
” or “ ” switch.
! Preparation for image quality and
volume settings
1. Turn the ignition switch to the “ON”
position.
2.Pullandholdthe“
/SET” switch
toward you to show the selection screen.
3. After the selection screen is displayed,
operate the “
” or “ ” switch to show the
“Display” item. Then, pull the “
/SET”
switch toward you.
! Contrast setting
1. Perform the preparation steps accord-
ing to “Preparation for image quality and
volume settings” F3-57.
2. Operate the “ ” or “ ” switch to
select the “Contrast” item. Then pull the
“
/SET” switch toward you.
Instruments and controls/Multi function display
– CONTINUED –
3-57
To Next Page
Loading...
