Instruments and controls/Multi function display
On an anniversary (displayed in orange)
NOTE
If “__” is selected for either the
“Month” or “Day” item instead of
numbers, the anniversary notification
will be deactivated.
! Clearing birthday or anniversary
1. Perform the preparation steps accord-
ing to “Preparation for date setting” F3-50
and display “Birthday” or “Anniversary” on
the screen.
2. Select the preferred birthday/anniver-
sary.
3. When “__” is selected for either the
“Month” or “Day” item instead of numbers,
the setting of “Birthday” or “Anniversary”
will be cleared.
! Daylight saving time setting
1. Perform the preparation steps accord-
ing to “Preparation for date setting” F3-
50.
2. Operate the “ ” or “ ” switch to
select the “Daylight Saving Time” item.
Then pull the “
/SET” switch toward you.
3. The current setting will be displayed.
Pull the “
/SET” switch toward you to
enter the selection mode.
4. Select “On” or “Off” by operating the
“
” or “ ” switch. Then pull the “ /SET”
switch toward you.
3-56
To Next Page
Loading...
