7. Select characters by operating the
“
” or “ ” switch. Then pull the “ /
SET” switch toward you.
– You can select characters of the
English alphabet (upper case charac-
ters and lower case characters are
available), eleven symbols or blank
spaces.
– The word being edited will be
displayed with an underline.
8. After entering the name by repeating
step 7, select “Set” by operating the “
”
switch and confirm the setting by pulling
the “
/SET” switch toward you.
9. The system will notify you that the
setting is complete.
If an anniversary is approaching, the
following screen will be displayed accom-
panied by a beep when the ignition switch
has been turned to the “ON” position. This
function can be set to on or off. For details,
refer to “Bypass screen setting” F3-65.
From 1 to 7 days prior to the anniversary
Instruments and controls/Multi function display
– CONTINUED –
3-55
To Next Page
Loading...
