SUMAVISION EMR Operation Introduction
12 /53
Chapter 4 Installation and Debugging
4.1 Unpacking and Checking
Please check whether the package of the device is damaged or not when receiving the
device; in case of device’s damage, please contact the carrier company or the After-sales
Technical Support Department of Sumavision in a timely manner.
If you complete the installation and debugging of the device by yourself, please pay
attention to the deformation of device and abnormal sound inside the device when
unpacking the device; check whether the device model and name are in conformity with
those specified in the contract; whether the serial number of device is identical to that in
the Delivery and Maintenance Certificate of Device; and whether the power lead,
connectors and fittings, operating instructions and Certificate of Fitness are completely
contained in the package case of the device.
If the installation and debugging are conducted by the after-sales technical engineers of
Sumavision, they will confirm the above-mentioned information with you.
You are required to sign and return the Delivery and Maintenance Certificate of Device to
our company after confirming there’s no problem upon the unpacking and inspection, and
according to which we’ll provide high-quality satisfactory after-sales services.
4.2 Installation Precautions
Check whether the environmental requirements in Section 3 of Chapter III have been met.
The device can be powered on for debugging after the installation is completed by
following the installation steps.
4.3 Steps and Methods of Installation
EMR needs to be installed and used on a 19-inch cabinet. When installing the device,
please open the box first, then take out the device. To ensure the device is installed firmly,
please put the device on L bracket after installing L bracket on the cabinet, and fasten the
device on the assembly cabinet with screws. Device installation can be shown as Fig. 4-1
Assembly cabinet for EMR.
To Next Page
Loading...
Need help?
General