SUMAVISION EMR Operation Introduction
47 /53
Chapter 8 Maintenance
8.1 Maintenance method
To make the EMR operate under the best operating status, extend the service life of
device, discover and eliminate the potential problems in time, and ensure normal
operation of the device, the routine maintenance must be carried out regularly.
The EMR should be maintained according to the following rules.
Must prepare for the detailed device maintenance target plan.
The EMR should be checked and maintained every day. If not, some small failures
will develop into worse, so proper daily inspection, monthly inspection, quarterly
inspection and annual inspection plans should be developed according to the
operation features of the device, including the maintenance and inspection class in
every period (class I maintenance, class II maintenance and class III maintenance)
and detailed maintenance contents.
Appoint the maintenance person.
It is the key for the device maintenance. The combination mode of “one person
inspection and several persons’ inspection” is recommended for EMR maintenance.
Establish the device maintenance archive.
The individual maintenance archive should be kept since the EMR is purchased till it
is abandoned. The maintenance and repair should be recorded in details. The
replaced and changed parts and wire should be marked on the circuit diagram and
device maintenance archive, so the diagram is consistent with the actual device.
Meanwhile, it can facilitate others to maintain and repair the device.
8.2 Maintenance details
The following details should be paid attention to in the routine maintenance of EMR
device.
The transmission device is of great importance, and should have trained person
for the routine maintenance.
Keep the site room clean, dustproof and damp-proof.
Follow the “Device Maintenance Target Plan” for routine inspection and test of
the device, and record the checking results.
Wipe the dustproof mesh of the fan every week. If the surface temperature of the
device is too high, check whether the dustproof mesh of the fan is blocked.
The device is inspected according to the specifications & instruction manual of
Sumavision Technologies Co., Ltd. The man-made accident should be prevented.
Wear the anti-static bangle when operating the device hardware.
To Next Page
Loading...
Need help?
General