SUMAVISION EMR Operation Introduction
4 /53
Run/Alarm
Operating indicators (1-6)
Connect to the power supply and turn on the power switch, the indicator of Power keep
lighting.
When the device starts and operates normally, there is no abnormalty, the indicator of
Run/Alarm on the device panel will turn green.
When the device operates abnormally, the indicator of Run/Alarm on the device panel will
turn red, which prompts the user that an error has occurred.
Operating indicators of 1 to 6 are used to indicate the operating status of slot 1 to 6
respectively, and the indicator of Alarm is used to indicate the device status.
＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝
After the device has been powered on, generally the indicator of power will keep
lighting once the device is started.
＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝
Table 2-1 Description for the operating status of indicator 1: lists the operating status of
indicator 1 by taking one MPEG2 analog encoding card in slot 1 as an example.
Table 2-1 Description for the operating status of indicator 1:
Indicator 1 can be divided into six kinds of status as shown in the table above, “Y” stands
for normal or Yes; “N” refers to abnormal or No; "-" denotes the content has nothing to do
with this item. For detailed alarm contents, please query in [Status Information] of
sub-cards in the menu of the device or in [Alarm Display] of Sumavision network
management system.
The operating indicator of slot 2, 3, 4, 5 and 6 has the same status of indicator 1. Here no
repeated description will be made.
2.2.2 LCD
Users can check IP address of the device and alarm information by querying LCD. Touch
To Next Page
Loading...
Need help?
General