SUMAVISION EMR Operation Introduction
16 /53
Chapter 5 Operating Methods
This chapter mainly introduces the methods for system setting and use of EMR, which
may be helpful for users to know initial knowledge about the system setting and operation
steps of EMR. The system setting includes device IP, user management, factory reset and
restart; and the operating method is composed of input setting, multiplexing setting and
output interface operation.
5.1 Web Network Management
When setting the EMR the first time, searching IP address may be required, which can be
realized through LCD on the front panel of the EMR by pressing the buttons, at this time,
the LCD would display local device IP and subnet mask. The computer will be set the IP
address again to make it be in the same network segment with EMR. Enter the IP address
of EMR in the IE browser: http://IP_address/, with the initial username as Admin and
password as sumavisionrd. The network management screen is shown as Fig. 5-1 EMR
WEB Network Management Screen.
＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝
The browser must support HTML 4.0. Internet Explorer 8.0 is recommended.
＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝
To Next Page
Loading...
Need help?
General