8-1
8.Administrator mode｜Logging in to and logging out of Administrator mode
8. Administrator mode
An administrator can edit splice/heater program parameters and function
settings which are not visible in Operator mode. The administrator can also
setup a password to keep operators from accessing functions.
The default password for Administrator mode is ‘００００’.
▸ P.8-2 Changing Administrator password
❚
Logging in to and logging out of Administrator mode
1: Open the Settings panel. Tap
“Login”.
3: After the entered password is
verified, “Administrator” label is
displayed on the Settings panel.
You are in Administrator mode.
Once you enter the password, you will remain logged in until you turn off the
power.
2: Enter the default password ‘0000’,
and tap “Done”( ).
Tap “Logout” on the setup panel to
log out of Administrator mode. After
logging out, you’ll be brought back
to Operator mode.
Logging out
To Next Page
Loading...
