2-17
2.Basic splicing operation｜Optical fiber splicing
2. Basic splicing operation
●
Starting the automatic splice
Here is a summary of the splicing operation procedures.
1: Slip a protection sleeve over the fiber.
2: Strip the fiber coating and clean the
fiber. If you have performed an arc test,
prepare the fiber again.
▸ P.2-11 Stripping the fiber coating
▸ P.2-12 Cleaving the fiber
3: Load a prepared fiber in the fiber coating clamp of the fusion splicer.
(▸P.2-14)
Tap the Set icon（）or press the Set key（）to start splicing.
2: Inspection of fiber end face &
dust.
4: Estimated loss is displayed.
After the splicing
process is complete,
▸Checking splice image and data P.2-18
▸Splice error possible cause and troubleshooting P.2-19
▸Proof test P.2-20
■Makin
a splice
Be sure to slip the fiber protec-
tion sleeve over one of the fibers
to be spliced before stripping and
cleaving the fibers. The fiber pro-
tection sleeve cannot be installed
after splicing.
1: Tap the Set icon ( ).
3: Arc is
enerated.
To Next Page
Loading...
