2-3
2. Basic splicing operation｜Preparing power supply
2. Basic splicing operation
The TYPE-72C+ is powered from AC adapter or battery.
1. Check the voltage of the AC power supply before use. Be sure to
ground the AC adapter by using a power cord with earth terminal.
2. The safety function may activate when voltage and frequency
beyond the specification are applied to the AC adapter, causing the
AC adapter to stop running.
In this case, the AC adapter needs replacing for a fee.
Contact our maintenance service center.
3. Place the AC adapter in a proper location so you can unplug the
power cord immediately in case of emergency.
❚
Preparing power supply
DC input terminal
Plugging
Insert the power cord into the AC adapter
completely.
Connect the output cord of the AC adapter
to the DC input terminal of the TYPE-
72C+.
●
AC operation
Connect the AC adapter (ADC-16) to the TYPE-72C+ when you operate the splicer on
AC power.
To Next Page
Loading...
