3-3
3. Maintenance｜Cleaning
3. Maintenance
If an unclear fiber image is still displayed
or LED error occurs again after cleaning
LEDs, clean the lens protection glass.
Lens protection glass
1: Remove the electrodes, referring to
the “Electrode replacement
procedures”. ▸P. 3-6
2: Prepare a cotton swab moistened
with alcohol.
3: Gently wipe the lens protection glass
in a circular motion.
4: Use a dry cotton swab to wipe off any
excess alcohol.
5: Re-fit the electrodes.
6: Perform an arc test.
If splicing is carried out right after electrode replacement, the splicer
cannot automatically adjust the arc center position, giving an error.
Please be sure to perform an arc test first.
*Do not apply too much
force when cleaning.
●
●
Cleaning lens protection glass
Do not use a canned air for cleaning.
Chemical reaction may deteriorate the
lens protection glass, resulting in a loss o
splicing performance.
An electrode tip is extremely
sharp. Handle with care.
To Next Page
Loading...
