7-2
7. Other convenient functions｜Universal clamp
7. Other convenient functions
❚
Universal clamp
The TYPE-72C+
can work with both tight buffer and loose buffer coatings as a
standard specification. Set the position of the lid of the coating clamp according
to the fiber coating type.
1: Loosen the coating clamp fixing screw to
remove the coating clamp.
Coating clamp
2: Open the lid of the coating clamp by
180°. The lid can be moved back and
forth. Set the position of the lid
according to the fiber coating type, and
then close the lid.
φ0.9mm coating
φ0.25mm
coating
Bare fiber
10mm
10mm
<Applicable cleave length for the universal clamp>
3: Re-fit the coating clamp back to the
splicer.
*Prepare the loose buffer fiber as below.
180°
Forth
Back
Coating clamp fixing screw
>>Tight buffer : back
>>Loose buffer : forth
Position of
the lid
Type of
fiber coating
Diameter of fiber coating
[μm]
Applicable cleave length
[mm]
Back
Tight buffer
Up to 250 5 to 16
Over 250 8 to 16
Loose buffer - NOT applicable
Forth
Tight buffer
Up to 250 5 to 10
Over 250 8 to 10
Loose buffer
250 primary/
900 secondary
10
(Refer to the figure above)
To Next Page
Loading...
