3-2
3. Maintenance｜Cleaning
3. Maintenance
Do not use a canned air for cleaning. Chemical reaction may
deteriorate the LED, resulting in a loss of splicing capability.
Dirt on a bare fiber pad will cause the fiber to be offset. When fiber offset occurs,
clean the bare fiber pad.
■ Cleaning bare fiber pads
Bare fiber pad
LED
LED
■ Cleaning LEDs
When a LED surface dirty, a fiber image is unclear, resulting in imperfect image
processing. If the display is uneven or LED error occurs, clean them with a
cotton swab moistened with alcohol.
1: Prepare a cotton swab moistened
with alcohol and wipe the surface of
bare fiber pads.
2: Use a dry cotton swab to wipe off
any excess alcohol.
*Do not apply too much
force when cleaning.
<Inside of hood>
1: Prepare a cotton swab moistened
with alcohol and wipe the surface of
LED lightly.
2: Use a dry cotton swab to wipe off
any excess alcohol.
●
●
Cleaning LEDs and bare fiber pads
To Next Page
Loading...
