Sumitomo TYPE-72C+ - DC Operation(Car Battery)

2-7
2. Basic splicing operation｜Preparing power supply
2. Basic splicing operation
The car battery cable PCV-16 (option) is required to operate the splicer on DC power
(car battery). Contact a sales representative.
• The battery pack is consumables. Repeated charging and discharging decreases
battery life.
• Store the battery pack within the following temperature range. Failure to do so
may lead to deterioration in performance.
*Battery pack storage temperature range:
-20°C ~ +50°C (if stored for less than 1 month)
-20°C ~ +40°C (if stored for less than 3 months)
-20°C ~ +20°C (if stored for less than 1 year)
• Do not use or store the battery pack at high temperature, such as in strong
direct
sunlight, in cars during hot weather. This may cause leakage of battery
fluid.
• If you are not going to use the battery pack for a long period, charge the battery
pack once every 6 months.
• If you are not going to use the splicer, remove the battery pack from the splicer.
When should the battery be replaced?
When the splice cycle decreases extremely with a fully charged battery, a new
battery pack should be purchased.
When disposing of the battery pack, contact our maintenance service center or
follow the local regulations.
•
It may take approximately 30 minutes before the battery pack goes into a quick
charging mode.
Please wait for a while after start char
g
in
g
.
Precautions for battery pack
●
DC operation (car battery)