Sumitomo TYPE-72C+ - Heater Program Editable Items

5-6
5. Heater program｜Heater program editable items
5. Heater program
The heating control system
Editable items Details
Operator Administrator
View
Edit
View
Edit
Name Allows to edit the name of Heater program. - -
✔ ✔
Abbreviated name Allows to edit the name of Heater program
which is displayed on the main screen.
✔ -
✔ ✔
Sleeve
Allows to edit the name of protection
sleeve.
- -
✔ ✔
Template Views an original Heater program which was
copied.
✔ - ✔ -
Note Allows to add a note to the selected Heater
program (up to 21 characters)
✔ ✔
✔ ✔
Preheating Temperature* Temperature for the pre-heating duration of
the heating cycle. (Numerical input)
✔*
✔*
✔* ✔*
Preheating Time* Duration for maintaining the Pre-heating
Temp. (Numerical input)
*When the heating process is started, the
pre-heating process is automatically
finished.
✔* ✔*
✔* ✔*
Heat Up Temperature A Heating element is heated up to the set
temperature in the first half duration of the
heating cycle. (Numerical input)
✔ ✔ ✔ ✔
Heating Duration A The first half duration of heating cycle.
(Numerical input)
✔ ✔ ✔ ✔
Heat Up Temperature B Heating element is heated up to the set
temperature in the latter half duration of the
heating cycle. (Numerical input)
✔ ✔ ✔ ✔
Heating Duration B The latter half duration of the heating cycle.
(Numerical input)
✔ ✔ ✔ ✔
Finish Temperature
Temperature which cooling operation lowers
to for completion of the entire heating
process. (Numerical input)
✔ ✔ ✔ ✔
Add Cooling Finish
Temperature
Sets the temperature of finishing the
additional cooling process.
✔ ✔ ✔ ✔
*For Quick of heater program
The heating control system is individually applied to each heater.
Preheating Duration
Heat up temp B
Finish temp
Pre-heating temp
Heating Duration B
Heating Duration A
Temp
Time
Heat up temp A
Heat Up Temperature A
Heat Up Temperature B
Preheating Temperature
Finish Temperature
Temperature
❚
Heater program editable items