1-10
1. Introduction｜Structure
1．Introduction
■Caution label
１
２
１
２
４
３
５
４
Installin
electrode
Before splicing make sure the
electrode is installed in the
splicer properly.
Hi
h temperature heater
The Heater reaches approx.
200°C. Take care when you run
the heater.
Hi
h volta
e
High voltage is generated in
the electrode during an arc.
Unplug the power cord and
remove the battery pack be-
fore you access the electrode.
Prohibition of usin
spray
Do not use any gas spray such
as gas duster or canned air.
３
５
Installing electrode
High voltage
High temperature
heater
High temperature
heater
Prohibition of using
spray
To Next Page
