6-3
6. Functions｜Operation Settings
6. Functions
Editable items Details
View Edit View Edit
Arc Pause
Stops the splicing process temporarily
before arcing. If you would like to check
fiber offset and fiber end faces during the
process, set this function to ON.
✔ ✔ ✔ ✔
Re-align After Arc Pause
Fibers are aligned again prior to splicing
after Arc Pause.
✔ ✔ ✔ ✔
Auto Start
Automatically starts the splicing process
when the fiber is inserted in the splicer and
the hood is closed.
✔ ✔ ✔ ✔
Heater Auto Start
Automatically starts the heating process
when the fiber is placed into the heat shrink
oven.
✔ ✔ ✔ ✔
Add Arc
Additional arc is available by setting this
function to ON. If an arc is insufficient, an
additional arc should be performed.
✔ ✔ ✔ ✔
Add Arc Settings
Allows to adjust the arc power for additional
arc.
✔ ✔ ✔ ✔
Ignore Cleave Angle Limit
If this item is set to ON, the splicer will
ignore a result of cleave angle inspection.
The default is OFF.
- - ✔ ✔
Ignore Cleave Errors
If this item is set to ON, the splicer will
ignore a result of cleaving quality
inspection. The default is OFF.
- - ✔ ✔
Fiber Insertion Screen
Single (X or Y) screen type or dual (X above
Y, X beside Y) screen type can be selected
in each step of the splicing process.→ For
more information, refer to the next page.
- - ✔ ✔
Pre-Fusion Screen - - ✔ ✔
Arc Screen - - ✔
✔
Post-Fusion Screen - - ✔ ✔
Est. Loss Screen - - ✔ ✔
Postsplice Action
(Proof-Reset)
Allows to select an action to be done after
splicing, i.e. a proof test is carried out or
not, and reset action is automatically
performed or not.
- - ✔ ✔
A pass code is required to log in to
Administrator mode. ▸P.8-1.
■ Operation Settings details
To Next Page
Loading...
