Sun Microsystems StorEdge 3510 Installation Guide

5-1
CHAPTER
5
FC Module FRUs
This chapter provides instructions for removing and installing field-replaceable units
(FRUs) in Sun StorEdge 3510 and 3511 FC arrays.
Topics covered in this chapter are:
■ “Replacing an I/O Controller Module” on page 5-2
■ “Saving the Configuration Settings to NVRAM” on page 5-2
■ “Removing an I/O Controller Module” on page 5-3
■ “Installing an I/O Controller Module” on page 5-6
■ “Monitoring the Automatic Firmware Update with a Recently Installed
Controller FRU” on page 5-7
■ “SES Firmware Update Sometimes Required with I/O Controller Module
Replacements” on page 5-8
■ “Converting a Dual-Controller Array to a Single Controller Array” on
page 5-10
■ “I/O Controller Replacement for a Single-Controller or Powered-Off Array” on
page 5-10
■ “Replacing I/O Expansion Modules” on page 5-11
■ “Removing the I/O Expansion Module” on page 5-11
■ “Installing the I/O Expansion Module” on page 5-11
■ “Installing Small Form-Factor Pluggable Transceivers” on page 5-12
■ “Installing a RAID/Expansion Chassis FRU” on page 5-14
■ “Converting an FC JBOD into an FC RAID Array” on page 5-17

Sun Microsystems StorEdge 3510 Specifications

General

Brand	Sun Microsystems
Model	StorEdge 3510
Category	Storage
Language	English