Intro(8)
Intro 1
NAME Intro - list the commands provided by the XSCF firmware
DESCRIPTION Intro(8) command lists the commands provided by the XSCF firmware of the
SPARC Enterprise™ M3000/M4000/M5000/M8000/M9000 servers.
Some commands are used in a different way or not supported on your server. For
details, refer to the pages of each command.
LIST OF
COMMANDS
In XSCF, the following commands are provided:
Intro, intro list the commands provided by the XSCF firmware
addboard configure an eXtended System Board(XSB) into the domain
configuration or assigns it to the domain configuration
addcodlicense add a Capacity on Demand (COD) right-to-use (RTU)
license key to the COD license database
addfru add a Field Replaceable Unit (FRU)
adduser create an XSCF user account
applynetwork reflect the information that has been set for the XSCF
network
cfgdevice connect a CD-RW/DVD-RW and TAPE drive unit to the
port, disconnect it from the port, or display the status of the
drive
clockboard set or display the clock control unit used at system startup
console connect to a domain console
deleteboard disconnect an eXtended System Board (XSB) from the
domain configuration
deletecodlicense remove a Capacity on Demand (COD) right-to-use (RTU)
license key from the COD license database
deletefru delete a Field Replaceable Unit (FRU)
deleteuser delete an XSCF user account
disableuser disable an XSCF user account
dumpconfig save system configuration information to a file
enableuser enable an XSCF user account
exit exit the XSCF shell
flashupdate update the firmware
fmadm fault management configuration tool
To Next Page
Loading...
Need help?
General
