showdualpowerfeed(8)
System Administration 347
NAME showdualpowerfeed - display the current setting of dual power feed mode
SYNOPSIS showdualpowerfeed
showdualpowerfeed -h
DESCRIPTION The showdualpowerfeed(8) command displays the current setting of dual power
feed mode in the system.
The showdualpowerfeed(8) command is valid in the M3000/M4000/M5000
servers only.
The dual power feed mode can be set by the setdualpowerfeed(8) command.
Also, before the dual power feed mode is changed by the setdualpowerfeed(8)
command, the values of changed settings are displayed.
Privileges You must have platadm or fieldeng privileges to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
EXAMPLES
EXAMPLE 1 Displays the current setting of dual power feed mode in the system.
EXAMPLE 2 Changes the dual power feed mode with the setdualpowerfeed(8) com-
mand and then displays the current state.
EXIT STATUS The following exit values are returned:
SEE ALSO setdualpowerfeed(8)
-h Displays usage statement.
XSCF> showdualpowerfeed
Dual power feed is enabled.
XSCF> showdualpowerfeed
enable -> disable
NOTE: Dual power feed will be disabled the next time the platform is powered
on.
0 Successful completion.
>0 An error occurred.
To Next Page
Loading...
