showstatus(8)
System Administration 445
NAME showstatus - display the degraded Field Replaceable Units (FRUs)
SYNOPSIS showstatus [-M]
showstatus -h
DESCRIPTION showstatus(8) command displays information about degraded units that are
among the FRUs composing the system.
Privileges You must have one of the following privileges to run this command:
useradm, platadm, platop, domainadm, domainmgr, domainop, fieldeng
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:.
EXTENDED
DESCRIPTION
The showstatus(8) shows the information concerning a unit failed or degraded
and the unit on the upper hierarchy, among the FRUs composing the system.
"Status:" will be followed by any of the status described below. Beside a unit
failed or degraded, placed an "*" indicating the locating fault.
EXAMPLES
EXAMPLE 1 Displays the degraded units. In this example, a CPU module and memory
-h Displays usage statement. When used with other options or
operands, an error occurs.
-M Displays text by page. This option provides a function that is the
same as that of the more command.
Status Description
Normal The component is normally operating.
Faulted The component is faulty and is not operating.
Degraded The component is operating. However, either an error has been
detected or the component is faulty. As a result, the component
might be operating with reduced functionality or performance.
Deconfigured As a result of another component's faulted or degraded status,
the component is not operating. (The component itself is not
faulted or degraded.)
Maintenance The component is under maintenance. A deletefru(8),
replacefru(8), or addfru(8) operation is currently underway.
To Next Page
Loading...
Need help?
General
