showhostname(8)
System Administration 373
NAME showhostname - display the current host name for the XSCF unit
SYNOPSIS showhostname {-a | xscfu}
showhostname -h
DESCRIPTION showhostname(8) command displays the current host name for the XSCF unit.
The host name is displayed in Fully Qualified Domain Name (FQDN) format.
Privileges You must have one of the following privileges to run this command:
useradm, platadm, platop, auditadm, auditop, domainadm, domainmgr,
domainop, fieldeng
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
OPERANDS The following operand is supported:
EXTENDED
DESCRIPTION
■ In the M8000/M9000 servers, a defect occurred on standby XSCF unit shows a
message.
■ The sethostname(8) command sets a host name for an XSCF unit.
EXAMPLES
EXAMPLE 1 Displays the current host names for all XSCF units.
-a Displays the current host names for all XSCF units. If an XSCF
unit name is specified with the -a option, the XSCF unit name is
ignored.
-h Displays usage statement. When used with other options or
operands, an error occurs.
xscfu Specifies the XSCF unit name to be displayed. One of the
following values can be specified. If xscfu is specified with the -a
option, xscfu is ignored.
xscf#0 XSCF unit 0
xscf#1 XSCF unit 1 (In the M8000/M9000 servers)
XSCF> showhostname -a
xscf#0: scf0-hostname.example.com
xscf#1: scf1-hostname.example.com
To Next Page
Loading...
