showntp(8)
System Administration 415
NAME showntp - display the NTP information which currently set for XSCF
SYNOPSIS showntp {-l | -a | address | -s | -m}
showntp -h
DESCRIPTION The showntp(8) command displays the NTP information currently set for XSCF.
The showntp(8) command can display the following information:
■ NTP servers which have been registered to the XSCF network
■ Status of synchronization with the NTP servers
■ Stratum value which has been set to XSCF
■ Designation of preferred server
Privileges You must have one of the following privileges to run this command:
useradm, platadm, platop, auditadm, auditop, domainadm, domainmgr,
domainop, fieldeng
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
-a Displays all the NTP servers currently set for the XSCF network.
-h Displays usage statement. When used with other options or
operands, an error occurs.
-l Displays whether synchronization with an NTP server is being
maintained.
-m Displays whether a preferred server designated. Either of the
following is displayed:
on Preferred server has been designated.
off Preferred server not designated.
-s Displays the stratum value which has been set to XSCF.
To Next Page
Loading...
