applynetwork(8)
System Administration 21
EXAMPLE 3 Reflects the information that has been set for the XSCF network. Suppresses
prompts, and automatically answers "y" to all prompts.
EXIT STATUS The following exit values are returned:
SEE ALSO rebootxscf(8), sethostname(8), setnameserver(8), setnetwork(8), setroute(8)
interface :xscf#0-lan#0
status :up
IP address :10.24.144.214
netmask :255.255.255.0
route :-n 0.0.0.0 -m 0.0.0.0 -g 10.24.144.1
interface :xscf#0-lan#1
status :down
IP address :
netmask :
route :
Continue? [y|n] :
y
Please reset the XSCF by rebootxscf to apply the network settings.
Please confirm that the settings have been applied by executing
showhostname, shownetwork, showroute and shownameserver after rebooting
the XSCF.
XSCF> applynetwork -q -y
0 Successful completion.
>0 An error occurred.
To Next Page
Loading...
